General Module Function
The create_fault_surface module creates a 3D grid that is aligned to a specified strike and dip.
Module Input Ports
1) This input field helps auto size and position your grid.
2) z_scale (Grey-Brown) : This port is for the z exaggeration factor.
Module Output Ports
1) z_scale (Grey-Brown) : This port outputs the z exaggeration factor.
2) out_fld (Blue-Black) : This port outputs a 3D field aligned to a specified strike and dip.
3) out_obj (Red) : This port outputs a renderable object representing the created fault surface
Module Control Panel
The Strike value of the grid can either be dialed in or set in the field.
The Dip value can be set using the slider.
The X Center, Y Center and Z Center set the position of the center of the grid.
The X Res and Y Res field set the resolution of the grid in nodes in the x and y directions.
The Width field scales the grid in the X direction.
The Length field scales the grid in the Y direction.