Selecting a pop-up command

Definition

A pop-up command instructs EVS to perform some operation. Pop-up commands appear when you press the right mouse button.

Where they apply

You can select a pop-up command for any of the following:

*  A module

*  A module's port

*  An opened window

*  A module connection line

Selecting a pop-up command

To select a pop-up command:

1.  For a module, move the mouse pointer to the module. If the module is open, point to the module's title bar or window frame.

For a port, move the mouse pointer to the port.

For an opened window, move the mouse pointer to an unoccupied area of the window.

For a connection line, move the mouse pointer to the line.

2.  Press down the right mouse button. A pop-up command list appears.

3.  Keeping the mouse button pressed down, move the mouse pointer to the desired pull-down command.

4.  Release the mouse button. The Network Editor executes the command.

You do not have to select a command from a popped-up command list. To remove the command list without selecting anything, move the pointer completely out of the command list, then release the mouse button.